PC stuck in attempting repair.

This response was truncated by the cut-off limit (max tokens). Open the sidebar, Increase the parameter in the settings and then regenerate.
If your PC is stuck in attempting repair, it can be a frustrating experience. This issue usually occurs when your computer is unable to boot properly and tries to repair itself automatically. However, sometimes the repair process can get stuck, leaving you with a non-functional computer. In this article, we will discuss some possible solutions to fix this issue.

Here are some steps you can take to fix a PC stuck in attempting repair:

1. Restart your computer: The first thing you should try is to restart your computer. Sometimes, a simple restart can fix the issue and allow your computer to boot normally.

2. Boot into Safe Mode: If restarting your computer doesn’t work, try booting into Safe Mode. This will start your computer with a minimal set of drivers and services, which can help you diagnose and fix the issue. To boot into Safe Mode, follow these steps:

– Press the power button to turn on your computer.
– As soon as the Windows logo appears, press and hold the power button to force your computer to shut down.
– Repeat this process two more times until you see the Preparing Automatic Repair screen.
– On the Preparing Automatic Repair screen, select Advanced options.
– Select Troubleshoot, then Advanced options, then Startup Settings.
– Click the Restart button, and your computer will restart in Safe Mode.

3. Use System Restore: If you have a restore point created before the issue occurred, you can use System Restore to revert your computer to a previous state. To use System Restore, follow these steps:

– Boot into Safe Mode.
– Select Troubleshoot, then Advanced options, then System Restore.
– Follow the on-screen instructions to select a restore point and restore your computer.

4. Use Command Prompt: If none of the above solutions work, you can try using Command Prompt to fix the issue. To do this, follow these steps:

– Boot into Safe Mode.
– Select Troubleshoot, then Advanced options, then Command Prompt.
– Type the following command and press Enter: sfc /scannow
– Wait for the scan to complete and follow any on-screen instructions.

5. Reinstall Windows: If all else fails, you may need to reinstall Windows. This will erase all your data and programs, so make sure you have a backup before proceeding. To reinstall Windows, follow these steps:

– Boot into Safe Mode.
– Select Troubleshoot, then Reset this PC.
– Follow the on-screen instructions to reinstall Windows.


Hopefully, one of these solutions helped you fix your PC stuck in attempting repair issue. If you’re still having trouble, it may be best to seek professional help or contact your computer manufacturer for assistance. Remember to always back up your important data to avoid losing it in case of a system failure. Good luck!

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *